Introduce the cutting principle and operation process of the paper tube cutter

The cutting principle of the paper tube cutter

The cutting principle of the paper tube cutter mainly relies on the rotation of the scoring wheel driven by the motor, as well as the corresponding fixing and transmission mechanisms. Specifically, when the motor starts, the scoring wheel starts to rotate and the paper core is fed into the cutting area under the action of the conveying mechanism. After the cutting position is determined by the positioning mechanism, the scoring wheel is in contact with the paper core and the cutting is made. Due to the high-speed rotation of the scoring wheel and the precise positioning control, it is possible to ensure that the cut paper core length is precise and the cutting surface is smooth.

The operation process of the paper tube cutter

The following is the general operation process of the paper tube cutter:

1. Boot Preparation:

• Inspect the working conditions of the equipment to ensure that the equipment is not fouled and there is no debris around.

• Check that the electricity and gas supply is normal.

• Prepare paper cores for cutting as needed.

2. Boot operation:

• Turn on compressed air (if applicable).

• Turn on the mains power supply and the power switch of the appliance.

• Press the start button, at which point the number displayed on the control panel may represent the position of the cutter or other relevant information.

3. Paper Loading Tube:

• Depending on the type of equipment, it may be necessary to open the paper tube chuck and fixtures through cylinders, valve handles, or other mechanisms.

• Thread the paper core from the designated position and clamp it in place.

4. Cutting Settings:

• Adjust the position of the cutter platform or related mechanism according to the length of the cut.

• Use a fixing mechanism to firmly fix the knife on the rotating shaft to ensure cutting accuracy.

5. Start cutting:

• Press the "Start" button to start rotating the axis.

• Press the "Feed" button and bring the cutter close to the paper core to cut.

• Press the "Retract" button as soon as the paper core is cut off.

• Press the "Reset" button to reset the position on the control panel to zero.

• Adjust the position of the cutter platform as needed to cut the next paper core.

6. Discharge tube:

• Stop the machine when the core cutting on the rotary shaft is finished.

• Open the paper core chuck and fixtures, remove the paper core and arrange it in a sorted manner.

7. Continuous Production:

• Repeat the steps described above for loading the tube, cutting settings, starting the cutting and unloading of the tube, and proceed to continuous production.

8. Shutdown Operation:

• Turn off the power switch and mains power.

• Sweep the cutter and debris from the fuselage.

Precautions

1. Equipment operation: The equipment should be operated by a special person, and other personnel are prohibited from operating it without authorization.

2. Safety protection: When the equipment is running, it is forbidden to touch any moving and rotating parts.

3. Problem handling: Problems found during operation of the equipment should be reported in time, and it is strictly forbidden to disassemble the equipment without permission.

4. Equipment maintenance: Maintain the equipment regularly, including replacing the scoring wheel, checking the electrical and hydraulic systems, etc.

By following the above operating procedures and precautions, you can ensure the safe and efficient operation of the paper tube cutter, while improving production efficiency and product quality.