Slitter machine work instructions

1. Overview

A slitting machine is a kind of equipment commonly used to process paper, film and other materials, which can cut a large width of material into the required small width. This work instruction is designed to introduce the operation process and precautions of the slitter in detail to ensure the safety and production efficiency of the operator.

2. The operation process

1. Preparation

a. Make sure the working area around the slitter is tidy and free of clutter.

b. Check whether the power supply and blade of the slitting machine are operating normally, if there is any abnormality, please report for repair in time.

c. Wear appropriate personal protective equipment, such as hard hats, protective glasses, protective gloves, etc.

2. Adjust the blade

a. Adjust the blade width and position of the slitting machine as needed to ensure that the width of the cut material meets the requirements.

b. Use special tools to adjust the blade and avoid touching the blade directly with your hands.

3. Set the cutting parameters

a. According to the type and thickness of the material, adjust the cutting speed and cutting pressure of the slitting machine.

b. Refer to the operation manual of the slitting machine and set the parameters according to the guidance.

4. Feeding

a. Place the material to be cut flat on the feeding table of the slitter.

b. As needed, use a special fixture to clamp the material to ensure that it will not move during the cutting process.

5. Start cutting

a. Press the start button to start the slitting machine.

b. Observe the movement of the material during the cutting process to ensure that the cutting line is straight and free of burrs.

c. If an abnormal situation is found, stop the slitting machine and check the reason.

6. Collect the cut material

a. After the cutting is completed, take out the cut material from the discharge port.

b. Stack the materials neatly and clean up the cutting waste in time.

7. Turn off the slitting machine

a. After the cutting work is completed, press the stop button to stop the operation of the slitting machine.

b. Turn off the power of the slitting machine to ensure safety.

3. Precautions

1. Safe operation

a. The operator should be familiar with the operation process and safety regulations of the slitting machine, and abide by the relevant operating procedures.

b. It is forbidden to put hands or other objects close to the blade area to avoid accidental injury.

c. During operation, pay attention to the safety of the surrounding environment to avoid collisions or other accidents.

2. Blade maintenance

a. Regularly check the condition of the blade, if it is found to be worn or damaged, it should be replaced in time.

b. Use special tools for blade replacement and avoid touching the blade directly with your hands.

3. Material selection

a. Choose the right material for cutting according to your needs, and avoid using too hard or too thick materials, so as not to damage the blade or affect the cutting effect.

b. If you need to cut special materials, please consult professionals in advance to ensure the safety of operation and cutting effect. 4. Troubleshooting

a. If you encounter a failure or abnormal situation of the slitting machine, you should stop the operation immediately and report for repair in time. b. Unauthorized personnel shall not disassemble or repair the slitting machine without authorization.

Fourth, summary

This work instruction introduces the operation process and precautions of the slitting machine in detail, and the operator should strictly follow the instructions to operate the slitting machine to ensure operation safety and production efficiency. At the same time, the slitting machine is regularly maintained and maintained to ensure its normal operation and cutting effect. If you have any questions or need further guidance, please consult the relevant professional in time.